2007 Arctic Cat ATVs factory service and repair manual, Page 322Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 322

2If the housing is damaged in any way, the housing must be replacedINSPECTING PRIMARY ONE-WAY DRIVE 3Install the pilot bushing
marks on the fixed face spring holder and both pulley faces 1Secure Driven Pulley Compressor (pln 0444-121) in suitable holding
fixture such as bench vise; then remove the wing nut, holding handle, flat washer, and pilot bushing leaving the large spacer
on the compressor tool base,CDo47 5Place the holding handle on the spring holder fitting the two dowel pins into the spring
holder face; then install flat washer and the win nutTurn the wing nut down until resistance is elt H NOTE: Do not use the