2007 Arctic Cat ATVs factory service and repair manual, Page 324Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 324

1 NOTE: Make sure the spacer is on the base or damage to the fixed face will occur when the spring is compressed Inspecting
the four pins and spacers into the fixed face hub: then pack the cam slots in the movable 4Inspect the pins and bushings
for wear, flat spots, looseness, or crackingAssembling 1Place the fixed face of the driven pulley on the pulley compressor
base making sure the dowel pins are engaged in the appropriate holes in the pulley facePage: 324 Arctic Cat ATV 2007 -All
Models 4Install the movable face sleeve aligning the hole in the spring seat with the spring anchor hole in the movable face-