2007 Arctic Cat ATVs factory service and repair manual, Page 325Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 325

5Install the spring over the hub and movable face sleeve; then insert the end of the spring through the sleeve and into the
guiding the spring holder onto the hubWhen slight resistance is felt, stop turning the wing nut 10Install the nut (threads
coated with red Loctite #271); then tighten the nut to specification using the spanner and torque wrench 7Assemble the notched-ring
nut, spring holding handle, one flat washer, and the wing nut in order on the pulley compressor bolt; then thread the wing