2007 Arctic Cat ATVs factory service and repair manual, Page 326Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 326

Servicing Center Crankcase Components Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
of machinist-layout dye to several teeth of the gear 1Place the left-side crankcase cover onto the left-side crankcase half
to prevent runout of the secondary transmission output shaft 4Install the secondary driven output shaft assembly5Rotate the
secondary driven bevel gear several revolutions in both directions6Examine the tooth contact pattern in the dye and compare
the pattern to the illustrationsIncorrect (contact at tooth top) 2Install the secondary driven output shaft assembly onto
the crankcase3Mount the dial indicator so the tip is contacting tooth on the secondary driven bevel gear4While rocking the
driven bevel gear back and forth, note the maximum backlash reading on the gauge5Acceptable backlash range is 0.03-0.15 mm
(0.001-0.006 inCorrecting Backlash 1 NOTE: If backlash measurement is within the acceptable range, no correction is necessary
1If backlash measurement is less than specified, remove an existing shim, measure it, and install new thicker shim 2If backlash