2007 Arctic Cat ATVs factory service and repair manual, Page 327Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 327

Correct Correcting Tooth Contact 1 NOTE: If tooth contact pattern is comparable to the correct pattern illustration, no correction
To correct tooth contact, steps and (with NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactIShim
Correction" chart must be consulted 3Maximum deflection must not exceed specificationsMeasuring Connecting Rod (Big End Side-to-Side)
A CAUTION After correcting tooth contact, backlash must again be checked and corrected (if necessary)Continue the correcting
backlashcorrecting tooth contact procedures until they are both within tolerance values 1Push the lower end of the connecting
rod to one side of the crankshaft journal2Using feeler gauge, measure the gap between the connecting rod and crankshaft journal
CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into the upper connecting rod