2007 Arctic Cat ATVs factory service and repair manual, Page 328Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 328

Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting rod at the big-end bearing2Acceptable
3Zero the indicator and rotate the crankshaft slowly A CAUTION 4Maximum runout must not exceed specifications 1Remove the
thrust washer (1); then remove the low driven gear (2) and the bushing (3) noting the orientation of the oil hole Care should
be taken to support the connecting rod when rotating the crankshaft 1 NOTE: Proceed to check runout on the other end of the
crankshaft by positioning the indicator contact at point and following steps 2-4 Measuring Crankshaft (Web-to-Web) 1Using
calipers, measure the distance from the outside edge of one web to the outside edge of the other web 2Remove the lowreverse