2007 Arctic Cat ATVs factory service and repair manual, Page 331Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 331

2Apply red Loctite #271 to the threads of the output shaft; then secure with the nutTighten nut to specifications; then using
of the shaft Assembling Crankcase Half 1Install the output shaft assembly into the crankcase making sure the driven bevel
gear, shim, washer, and nut are properly sequenced 1 NOTE: If heating the bearing is not possible, the crankshaft can be
installed using crankshaft installing tool 4Install the drive pin (4) in the crankshaft; then apply red Loctite #271 to the
threads of the crankshaft and install the crankshaft balancer drive gear (2), washer (3), and nut (1)Tighten to specifications;