2007 Arctic Cat ATVs factory service and repair manual, Page 333Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 333

10Install the reverse idler gear assembly noting the positioning of the two washers, gear, bushing, and shaft Joining Crankcase
or sticking occursI 6From the right side, install the rnm cap screws (two inside the case); then tighten only until snugl
NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 12Place the oil strainer into position in
the left crankcase half 7In crisscross pattern, tighten the mm cap screws (from step 5) until the halves are correctly joined;
then tighten to specificationsl NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 8In crisscross
pattern, tighten the mm cap screws (from step 6) to specificationsl NOTE: Rotate the shafts back and forth to ensure no binding
or sticking occurs13Install the two alignment pins in the left crankcase half VS- AT THIS POINT After completing center crankcase