2007 Arctic Cat ATVs factory service and repair manual, Page 341Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 341

Lubricate the inside wall of the cylinder; then using ring compressor or the fingers, compress the rings and slide the cylinder
onto the crankcase union and tighten the clampCCylinder Head 1NOTE: Steps 1-5 in the preceding sub-section must precede this
procedure 8Install the five 10 mm cylinder head cap screws and tighten in the se uence shown to an initial torque of 2.5
kg-m (18 ft-lb); then using the same sequence, tighten to final torque of 3.7 kg-m (27 ft-lb)1 NOTE: Apply engine oil to
the threads and both sides of the washers before installing the cylinder head cap screws 6Place the chain guide into the
cylinder Care should be taken that the bottom of the chain guide is secured in the crankcase boss 9Install the four mm flange-head