2007 Arctic Cat ATVs factory service and repair manual, Page 343Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 343

18Rotate the engine through three or four revolutions; then rotate to top-dead-center (TDC) on the compression stroke and
the magneto cover, install the camshafts with the engraved marks parallel with the top of the cylinder head and the and directed
toward the intake or exhaust side of the headt lU4UA 20Apply engine oil to the cylinder head cover seal washers; then install
the cylinder head cover cap screws and seal washersTighten in crisscross pattern to 1.0 kg-m (7 ft-lb)Repeat in the same
pattern to final torque of 1.4 kg-m (10 ft-lb) 17Install the camshaft holders on the respective camshaft with the arrows
directed toward the cam gears; then secure with the eight cap screws and tighten to specifications 21Install the coolant