2007 Arctic Cat ATVs factory service and repair manual, Page 352Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 352

NOTE: Check float arm height by placing the carburetor on its side wlfloat contacting the needle; then measure with caliper
initial setting NOTE: Note the locations of the jets and holder during assembling procedures 3Install the slow jetTighten
securely 4Install the main jet into the needle jet holder and tighten securely; then install the needle 'et and needle jet
holder assembly into the car uretor and tighten securely 7Place the U-ring into the pump housingPosition the spring and diaphragm
assembly (lip toward the carburetor) onto the carburetor; then secure the assemblv with the DumD housing and three screwssecurelyen