2007 Arctic Cat ATVs factory service and repair manual, Page 354Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 354

REMOVING 1Turn the ignition switch to the OFF position; then remove the ignition switch key Do not turn the ignition switch
disconnect the gasline hose connector from the fuel rail TROUBLESHOOTING Gasoline may be under pressurePlace an absorbant
towel under the connector to absorb any gasoline spray when disconnecting 1Verify that the electric fuel pump is operating
by listening for "whirring" sound for several onds after the ignition switch is turned to the ON positionIf no sound can
be heard, see Testing Electric Fuel Pump (700 EFI) in this section2Check for flashing EFI icon on the LCD displayIf EFI is
flashing, see ECU Error Codes (700 EFI) in Section 5 Fuel Rail 3Make sure there is sufficient, clean gas in the gas tank4Verify
that the battery is sufficiently charged to crank the engine over at normal speed6Remove the screw securin the throttle actuator
cover to the throttle body; en remove the cover 5Check the air filter housing and air filter for contaminationClean or replace