2007 Arctic Cat ATVs factory service and repair manual, Page 355Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 355

8Loosen the outer jam nut securing the throttle cable to the throttle body; then route the cable out of the way Connect the
all metallic components in wire basket and submerge in carburetor cleanerSoak for 30 minutes; then rinse with fresh parts-cleaning
solventFI104A 11Use tape to cover and seal the intake opening Wash all non-metallic components with soap and waterRinse thoroughly
Any objects or liquid entering the intake opening will fall into the engine causing severe damage if the engine is turned
over or started Dry all components with compressed air only making sure all holes, orifices, and channels are unobstructedInspect
the carburetor body for cracks, nicks, stripped threads, and any other imperfections in the castingInspect the vacuum pistonldiaphragm
for cracks, imperfections in the casting, or cracks and tears in the rubberInspect float for damageInspect gasket and O-rings
for distortion, tears, or noticeable damageInspect tips of the jet needle, pilot screw, and the needle jet for wear, damage,