2007 Arctic Cat ATVs factory service and repair manual, Page 359Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 359

1 NOTE: If the oil pressure is higher than specified, check for too heavy engine oil weight (see Section 2), clogged oil
located on the back of the radiator 1Remove the input and output hoses from the fittings on the cooler 2Remove the radiator
(see Radiator) in this section3Remove the fan and fan shroud; then separate the oil cooler from the radiatorINSTALLING the
hoses to avoid oil spillage 2Remove the cap screws securing the oil cooler to the frameAccount for grommets 1Place the oil
cooler into position on the radiator and secure with the retainer brackets; then install the fan shroud and fan 2Install
the radiator (see Radiator) in this section3Connect the oil hoses to the oil cooler and tighten the clamps securely 4Warm
up the engine and check for leaks; then shut off the engine and check for the pro er oil level on the oil level stickAdd