2007 Arctic Cat ATVs factory service and repair manual, Page 363Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 363

4From inside the left-front wheel-well, remove the two torx-head cap screws securing the fender to the frame CC786A DISASSEMBLING
then remove the impellerlshaftUsing Seal Removal Tool (pln 0644-072), remove the mechanical seal and the oil seal from the
bearing housing 6Using an impact driver, loosen but do not remove the two Phillips-head cover screws CLEANING AND INSPECTING
NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary 1Clean all oil-pump components