2007 Arctic Cat ATVs factory service and repair manual, Page 364Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 364

ASSEMBLING 1Place the new oil seal into the bearing housing; then using seal driver, gently tap the seal down until it is
the fender to the frame with the two torx-head cap screwsTighten securely Failure to properly engage the two shafts could
cause serious engine damage 5With the bearing housing assembly in position on the engine, place the cover (with O-ring installed)
into position on the housing; then loosely secure with the two Phillips-head cap screwsINSTALLING 1Secure the water pump
to the engine with the two cap screws tightened securely; then tighten the two Phillips-head cap screws securely 4Place the
footrest into position on the frame and loosely secure with four cap screws; then secure the front and rear fenders to the
footrest with the four torx-head cap screwsTighten the four tom-head cap screws securely; then tighten the remaining cap
screws to specifications 5Fill the engineltransmission with the proper amount of recommended oil6Fill the cooling system