2007 Arctic Cat ATVs factory service and repair manual, Page 366Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 366

INSPECTING u AT THIS POINT If the pump has failed earlier test and must b replaced, proceed to INSTALLING BEngage the tabs
lever 3Rotate the fuel pump until the match marks align; then install the mounting screws and tighten securely using crisscross
patternIf readings are erratic, clean the resistor wiper and resistor with clean alcohol and retestIf still not correct,
replace the fuel gauge tank sensori NOTE: 1 NOTE: It is important to install the fuel pump with the correct orientation to
ensure adequate float lever clearance 4To replace the fuel gauge tank sensor, use the following procedure ADisconnect the
two-wire connector (A); then press the fuel gauge tank sensor toward the top of the fuel ump to release it from the mounting
slot (B? 4Connect the wires, fuel hose, and spring clamp; then turn the ignition switch to the ON positionNote that the fuel
pump runs momentarily and the fuel gauge indicates the proper fuel level 5With the transmission in neutral and brake lever
lock engaged, start the engine and check for normal operationCheck for any fuel leaks 6Install any wire ties that were removed;