2007 Arctic Cat ATVs factory service and repair manual, Page 373Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 373

Fan Motor The connector is the black two-prong one located behind the fan assembly1 NOTE: The ignition switch must be in
there is any type of electrical system failure, always check the fuses first1 NOTE: The ignition switch must be in the LIGHTS
position troubleshoot the battery, fuse, motor, or the main wiring harness1 NOTE: If the meter shows battery voltage, the
main wiring harness is goodThe connector should be checked for resistance Remove all fuses from the distribution moduleSet
the meter selector to the DC Voltage position RESISTANCE (Fan Motor Connector) llwas disconnect the battery when performingl
(resistancetests to avoid damaging the multimeter- A CAUTION 1Set the meter selector to the OHMS position1 Connect the black
tester lead to groundUsing the red tester lead, contact each end of the fuse holder connector terminals individuallyThe meter
must show battery voltage from one side of the connector terminal ends1 NOTE: Battery voltage will be indicated from only