2007 Arctic Cat ATVs factory service and repair manual, Page 374Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 374

Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 1Set the meter selector to
The ignition coil is on the frame above the engineTo access the coil, the side panel (see Section 2) must be removedRESISTANCE
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 1 NOTE: For these tests,
the meter selector should be set to the OHMS position and the primary wire(s) should be disconnected Primary Winding 1Connect
the red tester lead to either terminal; then connect the black tester lead to the other terminal or on 500 models, to suitable