2007 Arctic Cat ATVs factory service and repair manual, Page 375Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 375

2On the 4001650connect the black tester lead to either primary connector; on the 5001700 EFI, connect the black tester lead
primary wire; then connect the black tester lead to ground3Crank the engine over using the electric starter4The meter reading
must be within specification2The meter reading must be within specificationIf the meter does not read as specified, replace
the spark plug cap1 NOTE: EFI Sensors Components PEAK VOLTAGE (400) 1 NOTE: All of the peak voltage tests should be made
using the Fluke Model 73 Multimeter (pln 0644-191) with Peak Voltage Reading Adapter (pln 0644-307)If any other type of tester
used, readings may vary due to internal circuitry1 NOTE: The battery must be at full charge for these tests CRANKSHAFT POSITION
(CKP) SENSOR To test the CKP sensor, see Stator CoillCrankshaft Position (CKP) Sensor (700 EFI) in this sectionAIR PRESSURE
SENSOR (APS) 1 NOTE: The CDI is located beneath the seat and fender panel near the battery 1Disconnect the APS connector