2007 Arctic Cat ATVs factory service and repair manual, Page 376Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 376

4Connect the APS to the harness; then using Maxiclips (pln 0744-041), connect the red tester lead to the brownlwhite wire
Sensor 1NOTE: Prior to testing the speed sensor, inspect the three-wire connector on the sensor harness (4001500 manual models)
or on the speed sensor (500 auto1650 HI1700 EFI models) for contamination, broken pins, andlor corrosion To replace speed
sensor, use the following procedure1Disconnect the three-wire connector from the speed sensor harness or from the speed sensor;
then remove the Allen-head cap screw securing the sensor to the sensor housing2Remove the sensor from the sensor housing
accounting for an O-ring 3Install the new speed sensor into the housing with new O-ring lightly coated with multi-purpose
grease; then secure the sensor with the Allen-head cap screw (threads coated with blue Loctite #242)Tighten securely 1Set
the meter selector to the DC Voltage position2With appropriate needle adapters on the meter leads, connect the red tester