2007 Arctic Cat ATVs factory service and repair manual, Page 377Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 377

9The meter must show less than ohm Ignition Switch On the 4001500, the connector is the black three-wire one beneath the
shows no battery voltage, troubleshoot the battery or the main wiring harness1NOTE: Handlebar Control Switches The connector
is the yellow one next to the steering postTo access the connector, the steering post cover and the right-side fender splash
shield must be removed (see Section 8)1NOTE: These tests should be made on the top side of the connector RESISTANCE A CAUTION
Always disconnect the battery when performing resistance tests to avoid damaging the multimeter A CAUTION Always disconnect
the battery when performing resistance tests to avoid damaging the multimeter 1 NOTE: Perform this test on the upper side
of the connector RESISTANCE (HI Beam) 1Turn the ignition switch to the ON position2Set the meter selector to the OHMS position
1Set the meter selector to the OHMS position2Connect the red tester lead to the yellow wire; then connect the black tester
lead to the gray wire3With the dimmer switch in the HI position, the meter must show less than ohm1NOTE: If the meter shows