2007 Arctic Cat ATVs factory service and repair manual, Page 378Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 378

1 NOTE: If the meter reads resistance, troubleshoot or replace the switchcomponent, the connector, or the switch wiring harness
black tester lead to the yellowlgreen wireWith the starter button depressed, the meter must show 0.5-0.7 DC voltsWith the
starter button released, the meter must show DC voltsConnect the red tester lead to the yellowlgreen wire; then connect the
black tester lead to the orangelwhite wireWith the starter button depressed, the meter must show DC voltsIf the meter does
not show as specified, replace the switchcomponent, connector, or switch harness1 NOTE: Front Drive Selector Switch The connector
is the two-wire black snap-lock one in front of the steering postTo access the connector, the cover must be removed1 NOTE:
Resistance tests should be made with the connector disconnected and on the selector-side of the connector RESISTANCE (Emergency
Stop) RESISTANCE 1Set the meter selector to the OHMS position2Connect the red tester lead to the orange wire; then connect