2007 Arctic Cat ATVs factory service and repair manual, Page 379Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 379

Connect the black tester lead to the negative battery terminalConnect the red tester lead to the red wire on the harness
tester lead to the switch terminal (leaving the wire connected) and the black tester lead to ground VOLTAGE Select the 2WD
position on the front drive selector switch; then disconnect the connector on the actuator wiring harnessWith the ignition
switch in the OFF position, connect the black tester lead to the black wire in the supply harness; then connect the red tester
lead to the orange wire in the supply harnessTurn the ignition switch to the ON positionThe meter must show 12 DC voltsConnect
the red tester lead to the whitelred wire in the supply harnessThe meter must show 12 DC voltsSelect the 4WD position on
the front drive selector switch; then connect the red tester lead to the whitelred wire in the supply harnessThe meter must
show DC volts1 NOTE: The 4WD icon on the LCD should illuminate 2Turn the ignition switch to the ON positionThe meter must
show 12 DC volts1 NOTE: If no voltage is indicated, check the wiring harness, fuse, or battery connections 3Select the lock