2007 Arctic Cat ATVs factory service and repair manual, Page 380Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 380

VOLTAGE (Stator Coil - The connector is the black three-pin one on the right side of the engine just above the starter motor1
meter selector to OHMS position VOLTAGE (Stator Coil 2Test between the three black wires for total of three testsRegulated
Output) 3The meter reading must be within specificationRESISTANCE (Trigger Coil) 1Set the meter selector to the DC Voltage
position2Connect the red tester lead to the positive battery post; then connect the black tester lead to the negative battery
post Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 3With the engine running
at constant 5000 RPM (with the headlights on), the meter must show 14-15.5 DC volts 1Disconnect the gray four-pin connector
on the right side of the engine just above the starter motor2Set the meter selector to the OHMS position Do not run the engine
at high RPM for more than 10 seconds1 NOTE: If voltage is lower than specified, test stator coilno load 3Connect the red