2007 Arctic Cat ATVs factory service and repair manual, Page 381Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 381

RESISTANCE (Source Coil) Magneto Coil (Trigger) 1Set the meter selector to the OHMS position2Connect the red tester lead
red tester lead to the yellow wire; then connect the black tester lead to the white wire 3Crank the engine over using the
electric starter4The meter reading must be within specification Magneto Coil (Trigger) 1Set the meter selector to the DC
Voltage position 2Connect the red tester lead to the green wire; then connect the black tester lead to the blue wire3Crank
the engine over using the electric starter Position (CKP) Sensor 4The meter reading must be within specificationMagneto Coil
(Source) VOLTAGE ( output) t 1Set the meter selector to the DC Voltage position 1Set the meter selector to the DC Voltage
position2Connect the red tester lead to the positive battery post; then connect the black tester lead to the negative battery
post 2Connect the red tester lead to the yellow wire; then connect the black tester lead to the white wire3Crank the engine