2007 Arctic Cat ATVs factory service and repair manual, Page 385Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 385

BTouch the black tester lead to ground brushCTouch the red tester lead to the brush holder assemblyW NOTE: If no resistance
the positive post, install an O-ring washer, fiber washer, flat washer, and lock washerSecure with the nut 5Apply small amount
of grease to the rear cover bushing; then install the cover on the starter housing making sure the reference marks align
3Ali the tab on the brush holder with the notch in starter housing; then install 6In order, install the thick metal washer,