2007 Arctic Cat ATVs factory service and repair manual, Page 386Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 386

7Apply small amount of grease to the front cover bearing and seal; then install the seal protector 10Apply small amount of
the emergency stop switch in the RUN position, the reverse lever (on manual transmission models) in the FORWARD position,
and the shift lever (on automatic transmission models) in the NEUTRAL position 1Set the meter selector to the DC Voltage
position2Connect the red tester lead to the starter terminal; then connect the black tester lead to ground 3With the starter
button depressed, the meter must show battery voltage and the starter motor should operate Place the front cover onto the