2007 Arctic Cat ATVs factory service and repair manual, Page 387Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 387

H NOTE: If the meter showed battery voltage but the starter did not operate or operated slowly, inspect battery voltage (at
it must be replaced The CDI is rarely the cause for electrical problems; howeverj if the CDI is suspectedj substitute another
CDI unit to verify the suspected one is defectiveH NOTE: Prior to replacing the CDI unit to assure the CDI unit is defectiver
it is advisable to perform CDI peak voltage test (see Ignition Coils in this section) andlor perform continuity test of the
wiring harness from the CDI connector to the CDI unit H NOTE: Make sure that the ignition switch is in the ON positionr transmission
in neutral, brake lock released, and the emergency stop switch in the RUN position 3Depress the starter button while observing
the multimeterThe multimeter should drop to volts and "click" should be heard from the relayW NOTE: If "click is heard and
any voltage is indicated by the multimeter, replace the starter relayIf no "clickrr is heard and the multimeter continues
to indicate battery voltager proceed to step Electronic Control Unit (ECU) The electronic control unit (ECU) is located beneath