2007 Arctic Cat ATVs factory service and repair manual, Page 388Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 388

Error codes can be cleared by following the procedures located in the ECU Error Codes (700 EFI) sub-section in this section
15.5 DC voltsr the regulator is faulty or battery connection is loose or corrodedClean and tighten battery connections or
replace the regulatorlrectifierIf voltage does not rise, check Voltage (Charging CoilNo Load) in this sectionIf charging
coil voltage is normal, replace the regulatorlrectifier4If the bulb fails to illuminate, it must be replacedVOLTAGE NOTE:
Perform this test in turn on the main harness side of all four connectorsAlso, the ignition switch must be in the LIGHTS
positionW NOTE: The LO beam is the outside bulb, and the HI beam is the inside bulb 1Set the meter selector to the DC Voltage
position2Connect the red tester lead to one wire; then connect the black tester lead to the other wire3With the dimmer switch
in the LO position, test the two outside connectors (LO beam)The meter must show battery voltage4With the dimmer switch in
the HI osition, test the two inside connectors (HI beam The meter must show battery voltage Neutral StartIFront Drive ActatorStart-in=Gear