2007 Arctic Cat ATVs factory service and repair manual, Page 389Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 389

Connect the power supply (positive) to the middle terminal; then connect the power supply (negative) to the bottom terminalThe
the meter shows no voltage, inspect fuses, wiring harness, connectors, and switches If sensor fails or an out-of-tolerance
signal is sensed by the ECU, an error code will be generated by the ECUThis will result in the analog needle swinging full
scale (LE model) or the LCD gauge going blank (standard model)The EFI icon will flashTo read the error code, use the following
procedure 1Make sure the ignition switch is in the OFF position; then remove the seat Always make sure the ignition switch
is in the OFF position before disconnecting the ECU VOLTAGE (Brakelight) H NOTE: Perform this test on the main harness side
of the connectorAlso, the ignition switch should be in the ON position and the brake (either foot pedal or hand lever) must
be appliedH NOTE: Make sure the brake lever (hand) and brake pedal (auxiliary) are properly adjusted for this procedure 2Locate