2007 Arctic Cat ATVs factory service and repair manual, Page 390Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 390

ECU Error Code List ECOOECIECIECIECIEC20EC21EC23EC24EC32EC40EC41EC99No Fault Detected CKP (Crankshaft Position) Sensor APS
the Diagnostic Harness (pln 0486-219) by connecting it to the diagnostic plug; then turn the ignition switch to the ON positionAfter
three seconds, turn the ignition switch to the OFF position and disconnect the diagnostic harnessWhen the ignition switch
is turned on, the error code should not be displayed Tilt Sensor Incorrect installation of the tilt sensor could cause sudden
loss of engine power which could result in loss of vehicle control resulting in injury or death OUTPUT VOLTAGE NOTE: Needle
adapters will be required on the multimeter leads as the following tests are made with the sensor connected Do not drop the
tilt sensor as shock can damage the internal mechanism SUPPLY VOLTAGE 1Connect the three-wire plug to the sensor; then remove
the right-side mounting screw securing the sensor to the rear frame 1Disconnect the three-wire connector from the sensor;