2007 Arctic Cat ATVs factory service and repair manual, Page 391Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 391

2Install the needle adapters to the multimeter leads; then select DC Voltage on the multimeter 3Connect the red tester lead
specified, the tilt sensor is defective NOTE: Prior to testing the TPS, inspect the three-wire plug connector on the main
harness and the three-pin plug on the TPS for contamination, broken pins, andlor corrosion 2Make sure the ignition switch
is in the OFF position; then select the DC Voltage position on the meter 3Connect the black tester lead to spade terminal
and the red tester lead to spade terminal ATurn the ignition switch to the ON positionThe meter should read 4.5-5.5 DC voltsrn
NOTE: When replacing the sensor after testing, make sure the arrow marking is directed up Page: 391 Arctic Cat ATV 2007 -All