2007 Arctic Cat ATVs factory service and repair manual, Page 392Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 392

4Remove the red tester lead from spade terminal and connect it to spade terminal BThe meter should read 4.5-5.5 DC voltsH
6Select the OHMS position on the meter; then perform the following resistance tests on the TPS APin (B) to groundinfinity
(open circuit)BPin (A) to pin (B)approximately 1.22k ohms (throttle closed)CPin (A) to pin (B)approximately 4.36k ohms (throttle
full-open) 9Select the DC Voltage position on the meter and turn the ignition switch to the ON positionThe meter should read
approximately 1.12 DC volts with the throttle closed and approximately 4.32 DC volts with the throttle in the full-open positionNOTE:
If the meter readings are as specifiedl check the main harness connector at the ECU main harness wiringIf the meter readings
are not as specifiedl replace the TPS and adjust to specifications (see INSTALLINGIADJUSTING in this sub-section DPin (A)
to pin (C) approximately 4.05k Always make sure the ignition switch is in the OFF position before disconnecting the ECU 10,