2007 Arctic Cat ATVs factory service and repair manual, Page 393Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 393

REMOVING 1Remove the left-side engine cover; then disconnect the three-wire TPS connector plug 4Turn the ignition switch
into position on the throttle body and secure with the two screwsDo not tighten at this time2, Connect the main harness to
the TPS3Locate the diagnostic connector under the seat; then install the test plug from Test PlugIError Code List Kit (pln
0444-216) onto the connector 5Tighten the mounting screws securely; then verify the TPS icon appears in the center position6Remove