2007 Arctic Cat ATVs factory service and repair manual, Page 396Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 396

Front Drive Actuator 1 NOTE: The actuator is not serviceable componentIf it is defective, it must be replacedi NOTE: The
must be replacedREMOVING INSTALLING 1Remove the left-front inner fender panel; then disconnect the connector on the actuator
harness 1Lubricate the O-ring on the actuator; then ensure that all mounting surfaces are clean and free of debris 2Using
T-30 torx wrench, remove the mounting cap from the driveshaft side of the actuator 2Align the actuator with the selector
shaft and slide it forward onto the shaft taking care to engage the cap screw in the slot of the front mounting tab 3Remove
the mounting cap screw from below the actuator on the suspension side3While holding the actuator Firmly forward, tighten
the front cap screw to hold the actuator in place; then install but do not tighten the two remaining cap screws Page: 396