2007 Arctic Cat ATVs factory service and repair manual, Page 397Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 397

Front Differential 1NOTE: To remove the rear gear case, see Rear Gear Case in this section REMOVING DIFFERENTIAL 1Secure
are loose to ensure proper seating of the actuator View from Beneath ATV0082; 5Tighten the remaining cap screws; then connect
the electrical plug to the main harness6Turn the ignition switch to the ON position and check the operation by shifting the
selector switch several times 3Remove the front wheels 4Pump up the hand brake; then engage the brake lever lock 7Secure
the wiring harness to the frame with nylon cable tie; then install the inner fender panel 5Remove the cotter pin securing