2007 Arctic Cat ATVs factory service and repair manual, Page 402Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 402

4On the 400500650install the input shaft into the housins: the1I install the front boot and secure withClamp (pln 0423-393)
2Using T-40 torx wrench, remove the cap screws securing the gear case coverAccount for and make note of the ID tag location
for assembling purposes 5Place the pinion housing with new gasket onto the gear case housing; then secure with the existing
cap screwsTighten to specifications1NOTE: If new gear case housing is being installed, tighten the cap screws to 3.5-4.3