2007 Arctic Cat ATVs factory service and repair manual, Page 404Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 404

1 NOTE: On front differential, the lock collar has right-hand threadsOn rear gear case, the lock collar has left-hand threads
proceed to the following Shimming Procedurelshim Selection sub-section Shimming ProcedureIShim Selection 8Using the Pinion
GearIShaft Removal Tool (pln 0444-127) and hammer, remove the pinion gear from the gear case housing 1Press bearings into
bores by outer ring to hard contact with seat 2Install the lock collar and tighten to specifications; then on final assembling,
stake the lock collar edge approximately 1.5 mm (0.060 in into the lower oil channel 9Secure the pinion gear in bearing puller;