2007 Arctic Cat ATVs factory service and repair manual, Page 408Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 408

3Using flat-nosed punch, drive the bearing out of the housing 3Install the pinion shaft and secure with the existing 48 mm
stake the lock collar to ensure that the collar will remain securely tightened 5Install the pinion housingRemovingInstalling
Axle Seal 1NOTE: This procedure can be performed on rear gear case 2Using suitable driver, install the needle bearing into
the gear case housing making sure the bearing is seated1NOTE: Do not push the bearing too far into the housing 1Remove the