2007 Arctic Cat ATVs factory service and repair manual, Page 413Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 413

8Apply 40 grams (113 of contents) of grease from the Grease Pack fuln 0441-173) into the knuck' les and the new outside boot
down into the recessed groove IDo no over-fill the joint as boot damage may occur1 (resulting injoint failure 9Slide the
new outside boot onto the shaft with the new clamps positioned as shownNote the different-sized clamps from removal1 NOTE:
The boot is positioned correctly when the small end of the boot seats down into the recessed groove 2Using the boot clamp
pliers, secure the small clamp of the inner boot 10Using CV Boot Clamp Tool (pln 0444-120), secure both outside boot clamps
3Apply 80 grams (213 of contents) of grease from the pack into the bearing housing4Install the bearing onto the shaft making