2007 Arctic Cat ATVs factory service and repair manual, Page 414Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 414

7Slide the boot over the housing; then using the boot clamp pliers, secure the boot with the clamp A CAUTION The bearing
6Making sure the marks made during disassembling align, slide the housing over the bearing ring; then completely seat the
bearing ring into the housing and install the circlip1NOTE: Pull the bearing ring out of the housing until it contacts the
circlip; then slide the ring in half wayThis will purge air from the housing and ensure the bearing is packed properly 3Place
the hub into position on the axle followed by hex nutTighten the hex nut finger-tight at this time 4If the brake calipers
were removed, position them on the knuckle and secure with existing cap screwsTighten the auxiliary brake caliper cap screws
to specificationsTighten the hydraulic brake caliper cap screws to specifications5Pump up the hand brake lever; then engage
the brake lever lock6Tighten the hub hex nut (from step 3) to specifications; then install and spread new cotter pin making