2007 Arctic Cat ATVs factory service and repair manual, Page 415Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 415

8Remove the ATV from the support stand and release the brake lever lock9Check the front differential oil level and add oil
REMOVING 1Remove the left-side rear A-arms (see Rear A-Arms in Section 7)2Remove both of the rear drive axles (see Drive
Axles in this section)3Remove the four cap screws securing the engine output shaft to the rear gear case input flange 4Slide
the hub wlbrake disc into position in the steering knuckle followed by washer and hex nutTighten finger-tight at this time
5Install the brake caliper on the steering knuckle Tighten to specifications; then pump up the hand brake lever and engage
the brake lever lock 6Tighten the hub hex nut (from step 4) to specifications; then install and spread new cotter pin making
sure each side of the pin is flush to the hub nut 4Remove the two cap screws and lock nuts securing the rear gear case to