2007 Arctic Cat ATVs factory service and repair manual, Page 416Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 416

u AT THIS POINT 3Remove the flange nut securing the hub4Remove the brake caliper For servicing the input shaft, pinion gear,
the hub assembly6Remove the four cap screws securing the brake discCLEANING AND INSPECTING 1NOTE: Whenever part is worn excessively,
cracked, or damaged in any way, replacement is necessary 1Clean all hub components2Inspect all threads for stripping or damageREMOVING
3Inspect the brake disc for cracks or warping4Inspect the hub for pits, cracks, loose studs, or spline wearINSTALLING 1Secure
the ATV on support stand to elevate the wheel: then remove the wheel Make sure the ATV is solidly supported on the support
stand to avoid injury 1Secure the brake disc to the hub with the four cap screws coated with blue Loctite #243Tighten to