2007 Arctic Cat ATVs factory service and repair manual, Page 421Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 421

10Remove the cap screws securing the A-arms to the frame 11Remove the circlip from the ball joint; then remove the ball joint
grease, oil, or dirt for installing purposes3Inspect the A-arm for bends, cracks, and worn bushings 4Inspect the ball joint
mounting holes for cracks or damage 4Secure the lower eyelet of the shock absorber to the upper A-armTighten nut to specifications
5Inspect the frame mounts for signs of damage, wear, or weldment damageINSTALLING 5Secure the A-arm assemblies to the frame
mounts (from step 2)Tighten the cap screws to specifications 1Apply green Loctite #609 to the entire outside diameter of