2007 Arctic Cat ATVs factory service and repair manual, Page 422Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 422

6Install the knuckle assembly onto the ball joints and secure with cap screwsTighten to specifications 10Secure the brake
11Secure the hub nut (from step 9) to the shaftlaxleTighten to specifications12Install new cotter pin and spread the pin
to secure the nut 8Apply grease to the hub and drive axle splines; then install the hub assembly onto the drive axle 13Install
the wheel and tighten to specifications14Remove the ATV from the support stand- Rear A-Arms REMOVING 1Secure the ATV on support
stand to elevate the wheels 9Secure the hub assembly with the nutTighten only until snug Make sure the ATV is solidly supported