2007 Arctic Cat ATVs factory service and repair manual, Page 429Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 429

7Inspect the handlebar tube for cracks, wear, or unusual bends8Inspect the handlebar grips for damage or wearINSTALLING 1Place
or damaged in any way, replacement is necessary 1Wash the tie rod ends in parts-cleaning solventD with compressed airInspect
the pivot area for wearApply low-temperature grease to the ends Always wear safety glasses when using compressed air 3Install
the tie rods and secure with the slotted nuts, Tighten to specifications; then install new cotter pinsNOTE: If the slots
do not align with the holes in the tie rod ends, tighten the nuts just enough to allow installation of the cotter pins 2Inspect
the tie rods for damaged threads or wear3Inspect the tie rods for cracks or unusual bends 4Inspect all welded areas for cracks