2007 Arctic Cat ATVs factory service and repair manual, Page 431Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 431

INSTALLING 1NOTE: Before installing grip, use contact spray or alcohol to clean the inside of the grip and the handlebar
AND INSPECTING 2Remove the wheel cap from the hub; then remove the cotter pin from the nut 1NOTE: Whenever part is worn excessively,
cracked, or damaged in any way, replacement is necessary 3Remove the nut securing the hub4Remove the brake caliper 1Clean
all knuckle components 5Remove the hub assembly 2Inspect the bearing for pits, gouges, rusting, or premature wear3Inspect
the knuckle for cracks, breaks, or porosity 6Remove the cotter pin from the tie rod end and remove the tie rod end from the
knuckle 7Remove the two cap screws securing the ball joints in the knuckle 4Inspect threads for stripping or damage 8Tap