2007 Arctic Cat ATVs factory service and repair manual, Page 434Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 434

distances from the inside rims to the frame tubes should be equalIf the measurements are equal, proceed to step 8; if the
mm (118-114 in toe-in (the front measurement 3.2-6.4 mm (118-114 in less than the rear measurement)12If the difference in
the measurements is not within specifications, adjust both tie rods equally until within specificationsi NOTE: Prior to locking
the jam nuts, make sure the ball joints are at the center of their normal range of motion and at the correct angle Ball Joint
Correct Angle lNOTE: The front wheels do not have to be removed to adjust the tie rodAlso, care should be taken not to disturb
the handlebar position Front Rack REMOVING 8Using permanent marker of some type, mark the center of each front tire (at height