2007 Arctic Cat ATVs factory service and repair manual, Page 435Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 435

3Remove the front rack from the ATVCLEANING AND INSPECTING 1NOTE: Whenever part is worn excessively, cracked, or damaged
the body; then remove the storage compartment and the steering post cover Front Bumper Assembly REMOVING 1Remove the two
flange bolts and lock nuts securing the upper bumper supports to the bumper 2Remove the through-bolt and lock nut securing
the bumper to the frame; then remove the bumperCLEANING AND INSPECTING 1NOTE: Whenever part is worn excessively, cracked,
or damaged in any way, replacement is necessary 1Clean all bumper components with parts-cleaning solvent2Inspect all welds
for cracking or bendingINSTALLING 1Place the front bumper assembly into and install the through-boltStart the ock nut and
finger-tighten only position Remove the left-side and right-side fender splash panels; then remove one press-in fastener
and one reinstallable rivet from the left side and right side of the air-intake splash shroudDo not remove the shroudDisconnect
the four headlight connectors and the taillightbrakelight connector from the sockets 2Install the two flange bolts and lock